Error Messages on TELUS Business Optik TV

Error code 403

This error can come up in different situations. The most common one is seen within applications like in our Video On Demand storefront. To resolve this problem, simply

reboot your digital box

.

Error code 0

Error code 505

LP1008

"Something unexpected happened. Please try again later (LP1008)." This error is due to a backend account linkage issue. To troubleshoot this issue, please make sure you:

If the issue persists, please

contact us

.

HD PVR is offline

Recording capabilities may have been disabled.

Contact us

and we will re-enable them for you.

PVR is starting, please wait...

After rebooting the PVR, it can take a few moments to be ready. The amount of time it takes depends on how many recordings there are. Simply allow the PVR a few moments and it will be ready on its own.

Account unavailable client has been disabled quit client

There may be a problem on our end. Please

contact us

to assist you.

Please enter a registration / activation code

Digital box should register automatically after a few moments if you acquired the digital box directly from TELUS. Otherwise,

contact us

and we will provide you with a registration code

Your television cannot support hdcp video over your high definition connection

When connections are attempted between your TV, your video cable and your digital box they can sometimes fail resulting in this error message. These errors can be random and sometimes more frequent but can often be resolved with a few simple troubleshooting steps. For more information, refer to

HDMI troubleshooting

.

Recording list is unavailable

When your digital box and PVR become out of sync, recordings will be unavailable. This error can also occur on the PVR when it did not boot properly. To resolve, simply reboot your PVR and allow it a few moments after it has tuned to a Live TV channel for the recordings to be available again.

The application you have tried to access is temporarily unavailable

Please allow a few moments and try again. If the issue persists, a reboot of the affected digital box may be required.

Optik TV is initializing

At this time, the digital box is attempting to connect back to our TV center. If the screen is seen longer than 15 minutes, please follow

My TV is initializing

.

Arris problem detected

Only comes up in a specific model of our PVR's. A reboot of the PVR should resolve the issue.

Green screen

Your digital box has gone into Standby Mode after 4 hours of inactivity. Pressing "" on your remote will bring Live TV back.