Program your Slimline Remote 2 for Optik TV

Stand 6-8 feet away from the TV and make sure there is a line of sight between the remote and the digital box

Make sure the digital box is on. Then turn on the device, such as your TV or amplifier, that you want your remote to control. This could be your TV or an amplifier

Before you program your TV or amplifier, set the digital box volume to 25 by using the remote volume button before you program a TV or amplifier

Press and hold the button for 3 seconds, until the green LED next to the Optik power button on the remote control flashes twice

Enter the 4-digit code for the brand of your device as listed in the

Remote Control Code List

. The LED light beside the TV power button will flash twice in red when a TV code is entered; it will flash twice in yellow when an amplifier code is entered. If this fails to work, use the

Remote Control Code List

to look up another code for your device brand and start again at step 1

Press and hold the button until your TV switches off

As soon as your TV switches off, remove your finger from the TV power button and press to confirm. The red TV light will flash twice

Press the button again to switch your TV back on

If you do not find a code that works for you try the following code: Press and hold the Options button for 3 seconds, until the green LED next to the Optik power button on the remote control flashes twice

For a TV, enter the code 0029 and your remote will search for a code that may work: This may take up to 15 minutes. The TV or AUX light will flash when complete. Press and then the TV should be synced.

You can set up your digital box and TV to turn on with one button press. Press and hold the button for 3 seconds, until the green LED on the remote control flashes twice

Enter code 0007 – The green LED will flash twice. The Optik power button will then turn on both your digital box and TV (It will also turn on your amplifier, if programmed). To turn power sync off, enter code 0006 and the green LED will flash twice