Gaming console issues with your Smart Hub

Connect your phone or computer to your ZTE hub via Wi-Fi or cable

Launch a web browser, and enter

https://192.168.0.1

in the address bar

You will be prompted to enter a password. The default password is “admin”

Select the disconnect button on the main screen (if you see "Connect," don't do anything)

Go to

Settings

Select on the left sidebar

Select

Select

Make a new profile with the following information:

Select

Select

Select and then . If the connect button doesn’t work, remove the battery and power cable, and after 2-3 seconds reconnect everything back. Press the power button 2-3 seconds to power on the device

Connect your phone or computer to your ZTE hub via Wi-Fi or cable

Launch a web browser, and enter https:// 192.168.0.1 in the address bar

You will be prompted to enter a password. The default password is “admin”

Toggle 4G LTE to , and select settings (the one located just under 4G LTE)

Select

Under mode, select , followed by

Enter the following information:

Select , then

Select and then toggle 4G LTE back

Connect your phone or computer to your hub via Wi-Fi or cable

Launch a web browser, and enter https:// 192.168.8.1 in the address bar

You will be prompted to enter a password. The default password is “admin”

Go to

Select on the left sidebar

Select

Select

Select

Select if "Pub" is selected as the default

Connect your phone or computer to your ZTE hub via your Wi-Fi network or a cable.

Launch a web browser, and enter

https://192.168.0.1

or

https://telus.smarthub

in the address bar.

You will be prompted to enter a password. The default password is located on the bottom of the Smart Hub under .

Toggle LTE+ to , and select (the one located just under in the upper-half of the middle circle).

Select .

Under , select , followed by .

Enter the following information:

Select , then select .

Go back to the homepage and toggle back to .

Connect your phone or computer to your TWH router via your Wi-Fi network or a cable. If you’re connecting via a cable, you can also plug the cable connected to the LAN/WAN an/wan port on the TWH router directly into your laptop or computer.

Launch a web browser, and enter or (

https://telus.smarthub

](

http://telus.smarthub

) in the address bar.

You will be prompted to enter a password. The default password is located on a separate sticker labelled for ODU 1.0 ZTE MC7010CA and the sticker labelled for the ODU 2.0 ZTE MC889CA. The password for both will be found next to .

Toggle or to , and select (found in the middle circle labelled ) .

Select .

Under , select , followed by .

Enter the following information:

Select , then select .

Go back to the homepage and toggle back to .`

Go to your Smart Hub settings

Select

Enable